Made this panel art using HueForge, think it turned out pretty well. Wanted to create something that was bigger than the bed plate would allow.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
Hatchbox Black
Creality Gray
Elegoo White
Hatchbox Blue
Plate 1 & 2:
Start with Black
At layer #10 (0.88mm) swap to Blue
At layer #14 (1.20mm) swap to Gray
At layer #16 (1.36mm) swap to White
Plate 3:
Swap Instructions:
Start with Black
At layer #19 (1.6mm) swap to Blue
At layer #23 (1.92mm) swap to Gray for the rest.