These clips make it easy to "tie" your shoelaces without actually tying them. The best part is that the clips are (almost) invisible because they fit on the inside of the shoe.
I rounded the edges so it is even more comfortable to wear!
Printing:
Print these clips easily and conveniently with a 0.4mm nozzle and standard layer height of 0.2mm. There's no need to go fancy with lower layer heights.
These clips print in just minutes.
Print in pairs of 4: 2 clips are needed for each shoe.
1. Place one lace clip on the inside of the shoe, with the flat side facing the shoe and the serrated edge toward the top of the shoe.
2. Push the lace up through the center hole (from the bottom to the top of the clip)
3. Push the lace down through the hole next to the serrated edge.
4. Fold the lace around the serrated edge and down through the remaining hole
5. You can cut off any excess lace.