Bambu P1S exhaust fan duct with magnets
Copyright Claim
Bambu P1S exhaust fan duct with magnets
Boost
37
68
7
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
1.6 h
1 plate
Boost
37
68
7
2
52
18
Released
Description
This is a magnetic fan duct for Bambulab P1S (but should work also for other models).
The exhaust duct can be used to connect a 10cm (4inch) hose directly to the printer and extract fumes.
The connection is grated with 10mm x 2mm magnets (8) directly to the metallic back panel.
I designed an L-shaped border to be used for gasket if needed (check photoes).
I hope this will be useful for your setup.
Please leave comments.
Bye
Comment & Rating (7)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
It prints beautifully. It does the job even in an X1C.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Perfect!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Hello! what is the pipe diameter and with what material did you print this adapter?
The designer has replied
0
Reply
Hi, pipe is good for a 10cm tube. I printed with PLA but it will print well with ABS and PETG too.
1
Reply
The material you see in photo is Alfa plus. A sort of PLA produced by Filoalfa. It's stronger than PLA if you recook after print. bye.
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld