Please Read!
This is an MTG Commander Deck Box that takes inspiration from the Eldrazis and their tentacles. I made this both because of my current commander, as well as the upcoming MH3 Eldrazis. This deck box will hold a 100 card sleeved commander deck, as well as any dice etc. that can be stored in the top tentacle part. The 2 main pieces go together by screwing them together. There is a clip that holds any dice that you put into the tentacle, and it is similar to the squeeze clips where you squeeze the 2 middle pieces together to put the cap on and off. While the top and bottom parts will be screwed together and unscrewed just fine, I used a bit of grease on the threaded parts to make it easier to take the top on and off, as plastic on plastic motion can be rough. I printed mine in black PETG, but PLA should work good. The tentacle, base, and cap need supports and I have marked where they need supports in the print profile. I recommend printing the tentacle part with a low layer height to make it smoother and make the middle less rigid. The base has a colorless mana symbol on the bottom, which is why it needs supports. If you want a version without the symbol leave a comment and I can upload it. There is an optional spacer included, as when I printed it I realized the cards would slide side to side, so the spacer makes them hold in place better.
If you have any questions or suggestions on the model, let me know and I will respond.