This is a remix of slavik.mis.1984.ve4's masking tape holder with two main changes:

• Added a ledge to the back to prevent the tape from tilting backwards and holding it more stable.
• increased the capacity so it can hold wider masking tapes (a rescale alone would not have achieved this as it woudl have made the base too big)

It should print well without supports or brims and doesn't need assembly or additional parts. I have found it extremely handy for my woodworking shop use. Thanks to the Slavik.mis.1984.ve4 and hope you enjoy as well.

I was also toying with changing the cutting edge geometry to support tougher tapes but found it unnecessary for general masking tapes. Let me know if you think it needs a modified cutting edge.