Magnetic Drawer style container!!

There are SIX MAGNETS 10mm x 3mm. Pauses are added to give you time to place magnets. Three of them go into the tall sleeve part. These three will attract to the build place, rather than the nozzle.

Three slide vertically into the holes on the left of the drawer part. I recommend a small dab glue inside the holes before you place the magnets, then another dab on top, let in set for a couple mins. This is to prevent the magnets from being attracted to the nozzle. There are a lot of ways to do this I'm sure.

Make sure the polarity of the magnets is proper. The Top of the magnets that are in the sleeve, need to be attracted to the left side of the vertical magnets in the drawer. If looking at the build plate from the front.