因为Bambu A1 并没有挤出机风扇,每次打印完,挤出机都非常烫,如果封箱这会更加严重,所以我做了这个挤出机散热风扇,选择得是淘宝上面的4CM的12V静音风扇,孔位为32MM-3MM,功耗很低
另外,因为A1也没有主板散热风扇,所以我也做了一个主板散热风扇,也是采用的一样的风扇
在装散热风扇需要注意先扣下前面,再扣下后面,主板散热风扇需要在内表面贴上双面胶
电源问题,需要找一个12V电源,可能需要焊接,当然您也可以选择USB风扇,或者AMSlite取电(没试过)
装配方面,你需要4颗12MM的M3螺丝
Because the Bambu A1 does not have an extruder fan, every time it is printed, the extruder is very hot, and if the box is sealed, this will be more serious, so I made this extruder cooling fan, and I chose the 4CM 12V silent fan on Taobao, with a hole position of 32MM-3MM, and the power consumption is very low
In addition, since the A1 does not have a motherboard cooling fan, I also made a motherboard cooling fan, which also uses the same fan
When installing a cooling fan, you need to pay attention to the front first, and then the back, and the motherboard cooling fan needs to be double-sided tape on the inner surface
Power supply problems, you need to find a 12V power supply, you may need to solder, of course, you can also choose a USB fan, or AMSlite to take power (haven't tried)
FOR ASSEMBLY, YOU'LL NEED 4 12MM M3 SCREWS