This is a tiny poop game inspired by Pucket.

Objective:
The objective of the game is to be the first player to clear all your poops from your side of the board by flicking them through the small slot in the centre.

Materials:

• Poop Pucket board
• 3D printer purge poops (pucks)
• Two rubber band, cut them and tie a knot, then place both of them into the slots (refer to the photo).

Setup:

1. Place the Poop Pucket board on a flat surface.
2. Each player takes their side of the board and fills it with their own 3D printer purge poops.

Gameplay:

1. Players take turns flicking their poops through the small slot in the centre of the board to the opponent's side.
2. Players must only use one hand to flick the poops.
3. The first player to clear all their poops from their side wins the game.
4. (Quick version) Set a timer for 3 min. When times up, the player has less poops on its side wins!

Special Rules:

• If a player accidentally flicks a poop off the board, the poop should return to the player's side.

The rule is up to you! Can be same as the Pucket or whatever you think is fun

If you have created your own rule, share your rule as a common below!