Self Watering Mini Bonsai Planter for your smaller trees! A1 mini compatible!
Internal reservoir that enables the soil to suck-up water as needed thanks to the cotton fabric rolls inserted into the drainage holes.
The single-piece design prints in place, no need for supports, rafts, or brims! All internal architecture is built-in.
The design is minimalist, and has a watering hole which doubles as a visual indicator of the water level inside the planter. The vent hole on the opposite side of the watering hole enables the water to move through all the voids and fill up the pot.
Printed with the fuzzy-skin effect which gives it the perfect stone-like look, perfect for your earth tone filaments!
After printing, simply cut up strips of old cotton fabric, roll them so that they are roughlt 8 mm in diameter (cotton string with the same diameter also works). Then insert the cotton rolls into the drainage holes and plant your tree, simple as that. See the images below for reference:
https://makerworld.com/en/models/385312#profileId-285652
https://makerworld.com/en/models/428240#profileId-332327