Model

Alternative inserts for neutral miniatures of Heroes of Might & Magic III The Board Game Stretch Goals

Two boxes that can store all neutral units. This box does not have a dedicated insert for specific miniatures. Big miniatures should be placed like in the photo. Miniatures on small bases can be placed randomly (if it fits - it fits). The lid is the same for both boxes. 

This insert:

• can speed up game setup;
• takes less space on the table compared to factory inserts;
• can be placed vertically on the table taking even less space;
• has an easily removable lid attachable with 3x1 neodymium magnets which you can find in a hobby or hardware store
• can be stored in the cardboard box of any expansion with up to 2 other inserts for faction miniatures

Printing recommendations

• Box geometry is optimized for FDM printing with a 0,4mm nozzle and 0,2 layer height
• Supports not required
• For best results calibrate the dimensional accuracy of your printer and filament

Assembly

Superglue 4 3x1 neodymium magnets in dedicated slots on the box and lid. (Dont mess up polarity ;)

NOTE:

No manufacturing process is perfect. Your specific miniature base can be a bit under/oversized from the factory. As a result, it may have a loose or tight fit. Fortunately, it can be fixed easily. You can use a small piece of sandpaper or a hobby file to enlarge the insert or put a layer of sticky tape to reduce the insert size. Alternatively, you can measure every miniature base size with digital calipers and modify the step file of the box in the CAD of your choice before printing.

P.S You can buy me a coffee if you like this model