打印耗材烘干增高架。打印推荐用PETG，0.3mm层高，不需要支撑。长宽大约为251mm x 218mm。四个零件每个都不同，都需要打印。

设计的比较紧凑，卡在托盘上也不容易掉下来。预留螺丝定位孔，可以电钻开孔，用螺丝固定四片增高架，一般来说不需要。烘干机是在淘宝上购买的。
【淘宝】https://m.tb.cn/h.5kcVYTA?tk=UqZ2WeBHyxG CZ0001 「虹魅 烘干机食品宠物零食水果蔬菜肉类风干机食物小型家用冻干机」
点击链接直接打开 或者 淘宝搜索直接打开

Filalment drying rack for food dehyradtors. Can be printed using PETG, 0.3mm layer height without support. All 4 parts are different and need to be printed. The length and width of the rack is around 251mm x 218mm. The rack should fit on the base tightly. There are locating holes on the rack, where screws can be inserted after being enlarged by a hand drill. The food dehyrator itself was bought on Taobao using the link below:

【淘宝】https://m.tb.cn/h.5kcVYTA?tk=UqZ2WeBHyxG CZ0001 「虹魅 烘干机食品宠物零食水果蔬菜肉类风干机食物小型家用冻干机」
点击链接直接打开 或者 淘宝搜索直接打开

Not sure if you can find the same product on Amazon, but you might use the fusion360 file to edit dimensions if the rack doesn't fit.