This allows you to display your keychains and other hanging items at shows you might be doing. I designed this and can be printed easily. Yes it is made to print out of PA6-GF. The profile is setup for PA6-CF. Still works just as good. The X1C currently only has the option to select on the printer itself PA6-GF but it's not an option in Bambu Studio's. I will watch and make adjustments later when they add this feature. Either way it prints amazingly at the settings I have dialed in and always pre-Heat your chamber before hand if you want flawless prints with this kind of material. I set the build plate to 120 for about 30 minutes and it's ready to roll.

Do Not run this material in your AMS. Use an external heated box for best results. If you decide to change it to another filament like PLA, ABS, ASA or even PETG I can't say it will print correctly or even hold up as well.  You could end up with warping issues with ASA or ABS cause of the design and I didn't set this profile up for the correct cooling with those materials.  The app will use some defaults which will warp.  In PA6-GF or PA6-CF my kids used this at their show without an issue and held the weight with every peg fully loaded with keychains. It was to cute! Enjoy and have fun!

You can use a bit of super glue or any type of good glue you find you like in the few key spots I've marked in the picture. It ensures the pegs and lower feet dont fall out.  In nylon 6 glass fiber reinforced you can even hit the pegs into the holes to drive them down deeper with out issues.  I always soak this print with hot water for about 5 minutes before assembly.   It will take any hitting you decide to do while putting it together.  The water will make the nylon stronger again and you will be good to drive the pins down with a small hammer.