A blend of artistic freedom and realistic representation.

Voronoi is used on the back (or front) of the pot leaf. When the light comes through, the whole thing blends together.

Flat, very easy print, use nozzle 0.4 and layer thickness 0.2.

The individual leaves can be gently shaped using heat, creating an even more realistic look. I used a bowl of hot water for this. (2nd photo is the model as it comes off the print bed, without bending)

A simple stand is added. If you want to plant the leaf somewhere else, then provide a hole of 2.7mm x 2mm and at least 5mm deep in your own model. (model at 100%).

Leaf is printed in slightly translucent green PLA.

Stand in the photo's is printed using fuzzy mode.