Inland Spooless to Bambu Spool Adapter by jantzenday

jantzenday

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.4 h

1 plate

4.8(6)

Boost

Released

Description

This simple adapter allows for Inland Spooless filament to be used on an empty Bambu spool. Once printed, remove the Bambu RFID cardboard liner from the spool, press the adapter inside the cardboard liner of the Inland Spooless filament, line up the groove in the adapter with the locator on the Bambu spool, and finally reassemble the Bambu spool. One end of the adapter (the end with the locator groove) is chamfered and fileted for easy alignment into the Inland carboard liner. The adapter is a snug enough fit inside the Inland liner that no slippage during printing should occur.

Comment & Rating (11)

@Madjp62

Print Profile

0.2mm layer, 2 walls, 15% infill

Could be a little bigger, but it works pretty good.

The designer has replied

@jantzenday

Bigger in diameter, you mean? It's a very snug fit into the spooless refills I've used. You may need to scale it up a bit for your printer.

@Madjp62

thank you

(Edited)

@jantzenday

Replying to @Madjp62 :

let me know if scaling it helps!

@ESPN8_TheOcho

Have you had much success with this? Unless i use a spooler, usually the Spooless rolls tend to get caught up in the AMS as the filament falls down the sides

The designer has replied

@jantzenday

It’s working great for me. I’m nearly halfway through the roll and I’ve been printing several models with multiple color changes.

(Edited)