Bambu Labs P1 Series XTouch Side Mount P1S - Dual Screen
Remixed by
Copyright Claim
Bambu Labs P1 Series XTouch Side Mount P1S - Dual Screen
Remixed by
Boost
6
19
6
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
V3 with flat top rail - 0.2mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
Boost
6
19
6
0
43
32
Released
Description
This mount is a modification, from another another great design, that moves your xtouch screen to right screen the P1 screen. Moving the screen to the side allows it to be out of the way from the glass, AMS, etc.
Since the xtouch will need a USB cable, this was designed to be used with a spacer like https://makerworld.com/en/models/159792#profileId-175411 . There is also a longer extension to keep the usb cable out of the way/hidden. Plus there is a cutout on the bottom to allow for the SD card and DuPont ports (temp or LED)
The back cover/screen will require 4 - M2.5 x 8mm (or even 10mm) screws.
Comment & Rating (6)
All
Print Profile
V3 with flat top rail - 0.2mm layer, 2 walls, 15% infill
Profile prints great, I adjusted slightly for PETG. The sacrificial layer on the screw holes is a little messy with PETG but fine after a little clean up.
Worth noting the design is for fairly small screw heads (~5mm), I had to find some as my usual batch are 6mm.
I'll going to make a remix compatible with the parallel screen mount I was using, this one would block the door of a P1S (I am yet to install my P1S parts) but will post when done.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
genau das wonach ich suchte👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
Remixes (1)
Related Models
© 2024 MakerWorld