Bed Fork for grabbing the bed without touching it with your greasy hands
Copyright Claim
Bed Fork for grabbing the bed without touching it with your greasy hands
Boost
2
5
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
27 min
1 plate
Boost
2
5
3
0
5
4
Released
Description
Designed for holding the bed without getting it greasy with your hands
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:It's just not strong enough to reliably hold the plate the way I expected. Printed really slow with PETG and 25% Gyroid unfill, still have to pinch the top to hold the build plate tightly. I will attempt again with PLA and Tough PLA to see if it's a material flexibility issue.
The designer has replied
0
Reply
The profile I uploaded should have been in PETG, but it was set to PLA. I printed it in PETG. I don't really have issues grabbing, and picking up the bed, but if it's tilted too far it will fall out. That is sort of intended, but I am working on a larger fork that will grab it a bit differently.
When grabbing textured beds the grabbing and removal of the print bed will strip away any grip over it's use which is hard to account for as well, but I have an idea for it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld