Corner Clamp for Woodworking
Copyright Claim
Corner Clamp for Woodworking
Boost
363
762
46
Print Profile(3)
0.2mm layer, 5 walls, 15% infill
Designer
7 h
1 plate
A1 Mini 0.2mm layer, 5 walls, 15% infill
Designer
7.8 h
2 plates
Tough PLA, 0.28mm layer, 3 walls, NO CLAMP
2.9 h
1 plate
Boost
363
762
46
6
582
365
Released
Description
📐Corner Clamp for Woodworking🪚
I needed some corner clamps for a woodworking project that I'm currently working on.
Most of the corner clamps I found still needed a traditional one-hand clamp for tightening, so I designed my own that are fully 3D printed and don't need additional parts.
I increased the wall count a little bit in the print profile to ensure that the parts are strong enough.
The thread in the rail may look a bit rough after printing, but it worked like a charm without post-processing.
You may also like:
 |  |
Comment & Rating (46)
All
Print Profile
0.2mm layer, 5 walls, 15% infill
So Usefull
(Edited)
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
great
0
Reply
Print Profile
A1 Mini 0.2mm layer, 5 walls, 15% infill
Dankeschön.
0
Reply
Very robust!
Printed on my A1 mini with eSUN's black PLA+ and SUNLU's red PLA+
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
the screw is too tight and it brakes. the corners are very good. use more tollerance and design the screw to be printed horizontal. you dont need a full cylinder so you can print it lay down. ✌️
0
Reply
Print Profile
Tough PLA, 0.28mm layer, 3 walls, NO CLAMP
Came out perfectly!
0
Reply
the screw just broke
The designer has replied
0
Reply
Nooooo 😭
0
Reply
Replying to @Sakul
Like the model and especially 100% 3D printed.
If I may suggest, if you put a 1 or 2mm hole through the center of the screw it will make it stronger (more walls).
0
Reply
Replying to @maunique
actually a good idea
0
Reply
Boosted
great model, sturdy and easy to use.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
Great idea and good design! Biggest issue is that it doesn't print the threads inside the hole (nut) well (X1C here). 75% of the threads on nut print fine, but those that are on top (hanging down) are a mess. I hoped the bolt might act like a tap of sorts (using PLA Tough). But it just shredded the nut threads. But the bolt and "nut" aren't needed. The 90 degree brackets alone should work. They do all the work, so a simple clamp squeezing those may be better (and less printing).
0
Reply
Boosted
La rosca excelente.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld