Adorable orb of a plump frog holding a heart <3

--------------

Below are some print setting suggestions for optimal quality:

1. Uncheck “slow printing down for better layer cooling” in filament profile, otherwise it leads to artifacts.
   
2. I've limited wall overlap and set both inner and outer walls to 0.42 for the best possible wall quality.
   
3. In my file, froggo is pointed toward the back corner of the print bed. This is normal and I did this to try to minimize stringing of black or red being dragged across the print. It's not necessary but I did find between test prints that it helped.
   
4. You'll notice the painting for the heart extends over the frog's hands.
   
   
   
   At this size, based on the way the layers go down on the rounded surface, there can be artifacts where the print color of the hands appears to escape onto the heart, and this is just based on the geometry of how the layers go down. This is very common for multi-color slicer painting, it is always a mistake to presume all boundaries you see in the Prepare tab are going to be translated into the Preview tab. After some testing, the painted overlap you see int he file worked best and gave a clean hand-heart separation line at this size.
   
   However, if you resize it, you may have to remove or adjust this overlap.