I'm having trouble printing TPU from FDPlast. The hardness of the rod is Sh A 75. Therefore, I was looking for a material feed from above, but taking into account my AMS installed on the stand ( https://makerworld.com/en/models/14025 ).
I liked the proposed model https://www.printables . com/model/298183-filament-spool-holder-adjustable-roller-style-easy. But it didn't fit my reel.
Additionally you will need:
Thread guide:
Bearings 693-ZZ (3x8x4) - 4 pcs.
Screw M3*12 - 4 pcs
Brass insert nut M3*5 - 4 pcs
Washer - 4 pcs.
Rollers (modified this model https://www.printables . com/model/530298-hydra-ams-improved-rear-rollers ):
Bearings 693-ZZ (3x8x4) - 4 pcs.
Screw M3*20 - 4 pcs (length may be different)
Support is only needed for sides-900-part1.
------------------------------------------------------------------
У меня возникли сложности с печатью TPU от FDPlast. Твердость прутка составляет Sh A 75. Поэтому искал подачу материала сверху, но с учетом моей AMS установленной на подставке ( https://makerworld.com/en/models/14025 ).
Понравилась предложенная модель https://www.printables . com/model/298183-filament-spool-holder-adjustable-roller-style-easy . Но не подходила по размеру для моей катушки.
Дополнительно понадобиться:
Направляющая нити:
Ролики (изменил эту модель https://www.printables . com/model/530298-hydra-ams-improved-rear-rollers ):
Поддержка нужна только для детали sides-900-part1.