benchy in inland PA-CF
Remixed by
Copyright Claim
benchy in inland PA-CF
Remixed by
Boost
1
1
3
Print Profile(1)
0.12mm layer, 3 walls, 20% infill
Designer
1.5 h
1 plate
Boost
1
1
3
0
38
27
Released
Description
this is my profile for the “Inland Carbon Fiber” its labled ePA-CF something or other on the side and these are the profiles i used.
Comment & Rating (3)
All
Epic failure for me. I printed on the textured PEI plate and after a few layers it started sliding all over the place and left a blob. I'm really baffled because I don't know where to start, but I'm so new, I don't even know what to ask. I'm not going to rate this anything in the off chance I did something horribly wrong.
0
Reply
Apply some glue to the plate?
0
Reply
Print Profile
0.12mm layer, 3 walls, 20% infill
good profile
0
Reply
No more
Related Models
© 2024 MakerWorld