Print Profile(1)
0.12mm layer, 4 walls, 40% infill
Designer
2.1 h
1 plate
Boost
6
7
2
0
13
12
Released
Description
a sturdy adapter piece to attach the broom handle to the broom. Simple but useful ;-)
print in PETG
Comment & Rating (2)
All
Print Profile
0.12mm layer, 4 walls, 40% infill
workes ok as long as not much force is applied. it eventually broke along the layer line
The designer has replied
0
Reply
If the printing parameters are set correctly so that good layer adhesion is guaranteed, this is not a problem. I have been using the part on a broom for a long time without break
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld