NES Controller box top (FLUSH) Remixed by Fat Tony

Remixed by

Fat Tony

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

Single AMS, Colored, Slowed 1st layer, Reduced 1st layer width

Designer

1.5 h

1 plate

4.0(2)

Boost

Released

Description

Remixed the Nintendo slide top to print face down making the model flush and allowing it to be printed completely support free. Model is setup for a single AMS

Get the bottom half of the box from the original creator at: https://makerworld.com/en/models/158784#profileId-174295

Recommended:

.16mm layer height
.32mm first layer width
White/Light Grey , Dark Grey, Black, Red

If first layer adhesion is a problem, try slowing down the first layer speed or running the first layer in “silent" mode. If all else fails you can always use hairspray, small text is not always easy to print.

Comment & Rating (4)

@FatTony

Love the box. Can't rate (assuming bc your print profile wasn't used?) but great work! I remixed the lid to print flush, face down to make printing easier and faster and remove the need for supports. Flush lid remix can be found here: https://makerworld.com/en/models/166359#profileId-182661 Thanks for the design and allowing me to remix it!