Large Rear Poop Bin for X1C, P1S, & P1P with Vibration Feet (with magnets) by calsynergy

calsynergy

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 10% infill

Designer

7.5 h

1 plate

5.0(1)

Boost

Released

Description

Is your side purge/poop bin taking up too much space on your table? This is the perfect print for that. It's a large rear only purge/poop bin with magnets! Reclaim that space with this print.

I have seen a lot of purge bins, but none that have added the additional height for the anti vibration feet. This is taller for all of us that use the anti vibration feet.

This print requires four (4) 6mm x 2mm magnets

This is a large rear only purge bin that is taller and wide to collect a ton of filament. I also have a file without magnets https://makerworld.com/en/models/162914#profileId-178843

Enjoy and please share!

Comment & Rating (4)

@user_1073692284

The top of the bucket did separate, and I fixed it with a bit of E6000 glue. It isn't fancy, but it gets the job done. I am printing a Symbiote/Spiderman statue which has 1164 layers and up to four color changes on many of the layers. I've tried to print it with a number of purge buckets, but each print failed because the bucket wasn't large enough or the angle on the slide was too low causing the poop to back up and clog the chute. This includes changing settings to reduce the amount of poop produced, but the poop still backed up and was dragged out of the chute and knocked over the prime tower. After that, there was no way to rescue the print. This basket is large enough for 8 or more hours of poop, so I don't have to monitor the print for 3 or 4 days.