A small plug for refilling liquid or (small) bulk material.
I designed it because I wanted to have a possibility to refill the cartridge of my automatic soap dispenser (Sagrotan No Touch).
The opening is around 20 mm which allows me to pour liquid soap through it without the need of a funnel.
Print it with TPU 95A (Tested with eSUN TPU-95A).
In my case it leaks air with a low rate at the connection between the original cartridge and the socket if squeezed . I tested it under water and there are some bubbels visible. So only use it on top as refill opening on stuff that does not require to be perfectly air-tight. Don't use it on pressurized stuff, too.
The wall thickness on the cartridge I used is around 1 mm.
Disclaimer:
This work by Himmelsnetz is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.