Tissue Box Brick (Small version)
Boost
90
139
16
Print Profile(1)
0.16mm layer, 2 walls, 15% inf
Designer
4.8 h
2 plates
Boost
90
139
16
0
201
182
Released
Description
Model made by me on Siemes NX, they are two pieces, which must be made on different plates. I didn't use any brims or supports, I used 0.16 as layer but it can also be made with other thicknesses. Container volume: 126x113x113mm.
Model achievable on any Bambulab.
Check out the bigger version of the tissue box
https://makerworld.com/en/models/166418
Comment & Rating (16)
All
Print Profile
0.16mm layer, 2 walls, 15% inf
scaled it up a little to fit the tissue box in …. awesome project
The designer has replied
1
Reply
thank you really much!🙏
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
This was a simple but outstanding design and print. It doesn't fit a complete square box of Kleenex cleanly, so I have to cut the top of the Kleenex box off in order to slide the Lego-like top on. This turned out great otherwise. Thanks!
The designer has replied
3
Reply
Thank you very much for the beautiful comment is much appreciated.
I made the design based on another brand I was hoping they were all the same😅
(Otherwise you could insert tissues without a box which should still work)
(Edited)
2
Reply
I had to completely remove them from the box. The lip the lid slides into broke when I tried to slide it on with the whole box in. :( The second one I'll print I'll slight scale up vertically.
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
lid is really loose and I didn't due my measurements great and kleenex boxes don't fit lol
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
Printed out great and worked fine
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
lid doesn't stay closed - ah, not square!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% inf
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld