X1 Carbon Poop Chute by MHilliar

MHilliar

3D Printer>3D Printer Accessories

GIF

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

11.9 h

2 plates

4.6(24)

Boost

142

373

201

Released

Description

Removable poop chute for X1C. Uses 4 3x6 mm magnetics and two 30x10mm magnets

If you have you printer sitting on someting or are using the feet that bambu sells youll need to make the feet for the chute taller to match the height of your printer.

FYI THIS WILL NOT FIT WITH THE AMS HUB IF YOU ARE USING MUTI-AMS UNITS. I WILL EVENTUALLY REDESIGN ONE THAT WILL

6x3mm magnets https://www.amazon.com/gp/product/B07873ZCY4/?ie=UTF8&th=1

30x10mm magnets aparently amazon no longer has a listing for these but you can find them on ali express.

Comment & Rating (33)

@Pisten76

Print Profile

0.2mm layer, 3 walls, 15% infill

Contenitore bello capiente, design ottimo. Si potrebbe migliorare il modello creando un incastro per i piedini perchè così come sono vanno semplicemente incollati senza una posizione precisa (si vede appena il centraggio sul fondo dello scivolo. Comunque lo consiglio.

@victorray

thanks this is a great design. great magnet action. i did have to snip the top off to fit ams hub.

The designer has replied

@MHilliar

I dont have the AMS hub. I ordered one and it should be here this weekend so if it doesn't work with that I may do a redesign.

@rd3dprt

Replying to @MHilliar :

I would also be interested in the design to accommodate the AMS hub.

@user_3567457977

Print Profile

0.2mm layer, 3 walls, 15% infill

everything printed great! Added the magnets and I’m all set, thanks!

@Webb

Print Profile

0.2mm layer, 3 walls, 15% infill

works amazing no more random poops flying across my counter lol

@Shrekinmypswamp

Print Profile

0.2mm layer, 3 walls, 15% infill

Failed

@GrandmaJustice

Print Profile

0.2mm layer, 3 walls, 15% infill

The chute itself did not fully print even after it said that it had printed 100%. Did not run out of filament and I'm not sure why it didn't. I will try to reprint it.

(Edited)

@Sunlight_Surge

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

printed fine but it would be nice if there were more small round magnets

(Edited)

@user_1459685670

This causes some issues with my X1E, blocks an inlet that I dont think the carbon has. So for other X1E owners, I dont think this is it for you.

@SunlightSurge

Neat design, unfortunately the four 3x6 magnets are not sufficient force to hold the bigger basket in place (when there's no ground support beneath it.) Would be cool if you added a few more round magnets so it has more attractive force.

(Edited)