Pillikan - Easy to print pill puncher
Copyright Claim
Pillikan - Easy to print pill puncher
Boost
50
70
17
Print Profile(2)
PLA, 0.28mm layer, 3 walls, 10% infill
40 min
1 plate
PETG, 0.28mm layer, 3 walls, 10% infill
45 min
1 plate
Boost
50
70
17
1
129
91
Released
Description
Pillikan is a very easy-to-print pill puncher to help elderly or disabled people open pill blister packs.
It helps to apply the required force to easily open the blister pack on almost any size of pill.
The small container underneath will catch the pill before it flys around the room.
It can be used right or left-handed, but if you want you can flip the model.
No support is required if you have good part ventilation. Just print it with the writing upside down.
We give all our work for free to the community, so if you like our work please consider donating a coffee (or a beer) to keep the project alive. Thank you
Comment & Rating (17)
All
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
easy print and works. good work
0
Reply
Print Profile
PETG, 0.28mm layer, 3 walls, 10% infill
nice clean print .. cutter could do with slight alignment change as doesnt quite aline with hole
The designer has replied
0
Reply
Hi
I tried several profiles to achieve the best result, indeed the hole is slightly offset but this is due to the model, the designer needs to make a slight modification
0
Reply
Replying to @Eskalibure
Its a good tool .. Its being used a lot and its v helpful for my aged relative .. comment was not a criticism just an observation
0
Reply
Replying to @Munichrich
Don't worry, I didn't take it as a criticism ;)
I made 3 myself for my wife who has hand problems
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
perfect profile
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
Nubbin is a bit too sharp\small. needs to be wider. hard to get to balance on the pill when pressing.
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
0
Reply
Boosted
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
0
Reply
Print Profile
PETG, 0.28mm layer, 3 walls, 10% infill
0
Reply
Print Profile
PLA, 0.28mm layer, 3 walls, 10% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld