1st test print with these settings, I think you can get away from the Agua Blue, didn't really add too much to the print.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA PolyLite Azure Blue Transmission Distance: 3
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA PolyLite Steel Grey Transmission Distance: 1
PLA PolyLite Aqua Blue Transmission Distance: 2.5
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Azure Blue
At layer #2 (0.24mm) swap to Charcoal Black
At layer #8 (0.72mm) swap to Steel Grey
At layer #15 (1.28mm) swap to Aqua Blue
At layer #16 (1.36mm) swap to Grey
At layer #18 (1.52mm) swap to White for the rest.