A1 Series - Goku Kanji Extruder Disk
Copyright Claim
A1 Series - Goku Kanji Extruder Disk
Boost
7
9
5
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
Boost
7
9
5
0
10
3
Released
Description
Hey guys! I'm back with my second model of the year so far and this time is an accessory to make my A1 power up and go OVER 9000! Lol.
There's a lack of Dragon Ball accessories available and I'm a huge fan so why not? I hope you like it as much as I had while making it!
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
i had an issue with the fit at first but it was definitely something my machine did! Awesome little decoration!
(Edited)The designer has replied
0
Reply
That’s odd cause it actually has a clearance of 0.15. Maybe look at your hole expansion setting? I have mine enabled but may not be on the profile. If it isn’t I’ll make the necessary changes ASAP.
(Edited)0
Reply
Replying to @JustKami
thanks for getting back with me ill check the expansion setting and see if that helps i tried another one also and same thing happened so most likely was something on my end thanks again!
0
Reply
it may be me but when i open this in bambu labs its only one color
The designer has replied
1
Reply
Yes, it's not made with an AMS as I don't have one so it's your traditional manual swap unless you already have an AMS which can do it for you. In the profile there should be some pauses added to the g-code at the right layers.
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld