Anchored (Anti-Slipping) Honeycomb Bathtub Hair Catcher
Copyright Claim
Anchored (Anti-Slipping) Honeycomb Bathtub Hair Catcher
Boost
12
24
7
Print Profile(1)
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
Designer
58 min
1 plate
Boost
12
24
7
0
38
44
Released
Description
This hair catcher fits most standard 40mm bathtub/shower sinks. A 39mm leg added at the base anchors the hair catcher in the sink hole. This addresses the slipping issue commonly seen with hair catchers without suction.
I have test printed this design to confirm that supports are not required for the “honeycomb dome” part of the hair catcher. The file is pre-supported and ready to print.
If your sink hole is larger or smaller than 40mm you can scale up or down the print accordingly.
This is my first design with Fusion 360 so please let me know if it works for you, or if there is anything I can do to improve it. Happy printing!
Comment & Rating (7)
All
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
fits our shower drain perfectly
0
Reply
Printed great, however, the lip/ledge leading up to the honeycomb dome seems to cause it to catch and hold water for a good while.
1
Reply
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
0
Reply
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
0
Reply
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
0
Reply
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
0
Reply
Print Profile
Standard 100% (39mm anchoring legs); 0.2mm layer, 2 walls, 15% infill, normal supports
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld