good model, so beautifull

Everything printed out very nicely! I was able to glue the halves and base together easily. It may be nice to have guides to align the halves a little easier but that’s a minor thing.

Mario star on top of the tree love it!!

I used Bambu yellow glow PLA and all the included settings. it was a little stressful to watch print, but the finished product is absolutely flawless. I only had black in ASA from 3dxtech so the base turned out a little wonky but that was my fault. it was a little difficult to hold together & align while the glue dried, so maybe including an optional alignment tool would be nice. it has little holes inside the star points, so maybe even cutting some toothpicks down would have helped. regardless, I love it, my wife loved it, everyone I sent pics to loved it. :)

profile has it laying down to print, it should be standing otherwise print quality is fairly bad regardless of settings plus gluing the 2 halfs together is a pain.

works fine!!

perfect fit.

I can't get on the software yet because I only have my phone but can you makes this so the eyes are separate since I gout glue them in