Running out of room in your Arrow shed? Time to mount some of your Makita tools to the ceiling!

Print in PETG or ASA, depending on how hot the roof gets.

I used 6 perimeters and 30% infill.

I also mirrored it, so it would work on the other side, without realizing that the Makita base itself is not symmetrical, so I'll try to do a mirrored version later that works properly - but no promises.

It installs at an angle, and is VERY tight. Then, 2 screws or nuts/bolts will hold it to the holes in the roof beam of your shed.