Oilers Logo Case or Lightbox
Copyright Claim
Oilers Logo Case or Lightbox
Boost
11
15
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.1 h
2 plates
Boost
11
15
9
3
45
38
Released
Description
Notes
- This is a decorative Oilers logo light box or case. You can also install LED lights and hot glue a battery holder with a USB port to the back cover to create a wireless lightbox as I have done here.
- Print with the logo side face down on a texture PEI plate for best results
Comment & Rating (9)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
great file. settings are on par ! keep up the good work
0
Reply
Boosted
Amazing File, Settings Work Great ! GO OILERS GO!
0
Reply
Question as its hard to see in the pictures, is the bottom of the box flat at all to prevent it rolling?
The designer has replied
0
Reply
Ah no it's not flat unfortunately, I was thinking I could design a separate stand in the future.
0
Reply
good looking model. I have a question about your placement of the battery box. Do you get shadows on the front of the light box ? thanks
The designer has replied
0
Reply
If the LEDs are lined up all around the logo I did not have shadows on mine!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld