Standard Caliper Hanger for Hex System HSW
Copyright Claim
Standard Caliper Hanger for Hex System HSW
Boost
15
43
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
42 min
1 plate
Boost
15
43
10
0
103
65
Released
Description
This is a caliper hanger for the HSW hex system. There are a couple others I found on makerworld however mine prints flat on the build plate for a precise fit without support at the hex. Support is still likely required on the angled sides that support the caliper jaws.
Comment & Rating (10)
All
A bit too tight for my caliper, but it'll do for now. Thanks for the model!
The designer has replied
0
Reply
Thanks for the feedback. Is it the width where the caliper body fits? Maybe I can loosen that tolerance a little and post a revision.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print is good, but it was too tight for my caliper
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super👌
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld