Super Mario Super Star clock by Rangebear

Rangebear

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 5 walls, 100% infill

Designer

2.8 h

1 plate

4.4(5)

Boost

Released

Description

Super Mario Super Star clock

Print 100% infill, colour as you like, i suggest you put it face down in case you have a PEI, makes a nice finish.

I used a cheap AE clock mechanism, you can use any other, however fill or widen the hole in the middle with the “add modifier” option in slicer.

I recommend a bigger layer height on the first layer to really make a nice squished first layer.

Link to the mechanism i used : Mechanism

Comment & Rating (6)

@user_2582061435

Print Profile

0.2mm layer, 5 walls, 100% infill

Sehr geil könnte hinten noch dickerer rammen ran zu anhänger sonst top

@A.Zwart

Print Profile

0.2mm layer, 5 walls, 100% infill

nice design, sizing description would be useful, clock hole did not fit. you can't see that from the bambu app. This means that the print cannot be used without post-processing.

The designer has replied

@Rangebear

Your right, i did not think about that description is not seen. I have added a description though and its meant to be drilled or something as there are so many mechanisms its impossible to fit them all. I added one that fits though and a link. Thank you for the feedback though. Hope you still enjoy it when on the wall :)

(Edited)