Print Profile(2)
One left, One right - 0.2mm layer, 4 walls, 15% infill
46 min
1 plate
0.2mm layer, 4 walls, 15% infill
49 min
1 plate
Boost
14
35
27
0
149
124
Released
Description
Lever type laptop stands Left and Right sides which give a ~10 Degree keyboard angle and raise the screen ~50mm. Designed to work on a Dell M3800 laptop which is15mm thick but should suit laptops up to 25mm.
Print Settings
Printer:
Raise3D N2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.15
Infill:
20%
Notes:
Designed to work without supports, may need rotating so flat face is on the build plate
Comment & Rating (27)
All
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
Works great. I scaled them up a bit to fit larger laptops (what I needed).
Small, lightweight, and effective
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
Printed very smooth and quick, would recommend!
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
didn't work for an older laptop (thicker profile then it was meant to/keyboard in the way), used it for work laptop instead. also didn't have to design one, so win for me.
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
perfect
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
(Edited)
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
(Edited)
0
Reply
Works with Dell G15
1
Reply
Works with a Thinkpad T-51.
1
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
Drück war ausgezeichnet nur rutscht der Laptop wenn man dran kommt.
0
Reply
Print Profile
One left, One right - 0.2mm layer, 4 walls, 15% infill
good for gigabyte
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld