Designed this Apple Watch Stand that allows each part to be printed in any color and then put together to complete the stand. Minimal to no glue is required, I did personally add one spot of super glue to keep the top side tab of the ‘Mid’ piece in place.
In my home / office I have came across 3 difference charging cables that have slightly different dimensions, so I have made a ‘Charge’ face for each one. Simply measure your charging cable to determine which one to print.
Construction:
- Assemble the ‘Charge’ face with your charging cable. Start by sliding the USB-A / USB-C end through the ‘Charge’ face. Secure the cable side in the ‘Charge’ face and then push the opposite side of the charger in. Pull the cable through the ‘Stand’ from the top and snap the ‘Charge’ face into place.
- Add the ‘Mid’ piece by sliding it into the ‘Stand’. Secure / align the lower side tabs and then align the top side tabs.
- NOTE: I added one little spot of glue to the longer tab to help keep the top side tabs secure.
- Add any extra cable inside the ‘Stand’ before snapping the ‘Bottom’ face into place.
- NOTE: I added some non-slip rubber pieces to prevent any sliding.