Flex Clip
Remixed by
Copyright Claim
Flex Clip
Remixed by
Boost
1
3
3
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Boost
1
3
3
0
19
15
Released
Description
Remix of the Flex Clip by dr_chunks on Thingiverse
I appreciate any support whether it's just a like an download or if you buy me a coffee (I drink a lot of coffee so anything helps haha)
The two integrated support posts have been removed and I added support painting to the section that needs support.
I found this model on makerworld earlier this week and found it very useful but it was removed for some reason.
The default print profile added is at .28mm layer height so the clip has a model printing time of just over 9m, I have printed and tested it at .28mm layer height and it functions great.
Comment & Rating (3)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
kinda works not enough spring to hold a bag closed
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld