I was getting annoyed a bit about delivery drivers unable to locate the bell, which is oddly shaped, so wanted to get a ring this bell sign, but the ones in amazon were approx 20 dollars, which is quite pricey. So I decided to put this together with the makerlab, and it came out fab.

Recommended Print material:

• ASA ( if exposed to sun, so your print colors don't degrade over a period of time)
• ABS ( if not exposed to too much sun )
• PLA.( if not exposed to any sun )

I printed mine using; Polymaker PolyLite ASA Yellow and PolyLite ASA Black.

Use the standard print profiles.

Powered by Make My Sign from MakerWorld(makerworld.com/makerlab/MakeMySign)