Hey there! This piece is a support I designed specifically to hold a pole of filament spools inside a dehumidifier box. It's super handy for keeping everything organized and protecting your 3D printing materials. A simple yet effective solution to optimize your printing setup!

• Two lateral angles for the firmness and one in the lower part for the support.
• Added an extra support at the bottom to help support more weight.
• Round out a lot of the support because it had to withstand spools and I did not want the edges to slow down the spool
• 20mm Pole
• 6mm Screws

Print Settings

• Designed in:
  • Fusion 360
• Printer brand:
  • MakerBot
• Printer:
  • MakerBot Replicator+
• Rafts:
  • No
• Supports:
  • No
• Resolution:
  • 0.1
• Infill:
  • 10
• Notes:
  • It depends on whether you need to support a lot or little weight. With 10% and thanks to the support added below is enough.