Page Thumb Holder
Copyright Claim
Page Thumb Holder
Boost
26
50
33
Print Profile(3)
0.16mm layer, 3 walls, 8% infill
Designer
27 min
1 plate
Regular print, 0.2mm layer, 2 walls, 15% infill
18 min
1 plate
0.2mm layer, 2 walls, 9% infill
23 min
1 plate
Boost
26
50
33
1
94
178
Released
Description
Simple yet useful thumb page holder. It's very comfortable to use and uses little filament to print. Not much to it :)
Comment & Rating (33)
All
Print Profile
0.16mm layer, 3 walls, 8% infill
Prints fast, light & smooth in hands, very practical!
(Edited)
0
Reply
Print Profile
Regular print, 0.2mm layer, 2 walls, 15% infill
Useful print for a book reader. Nice design
0
Reply
Print Profile
0.16mm layer, 3 walls, 8% infill
Printed perfectly and works great!
0
Reply
Print Profile
0.16mm layer, 3 walls, 8% infill
Printed mine at 0.2mm LH - 10% infill. Still came out clean!
0
Reply
Print Profile
0.16mm layer, 3 walls, 8% infill
Came out great. Bambu pla matte dark blue (11602)
0
Reply
Print Profile
0.16mm layer, 3 walls, 8% infill
Zero problems. Nice smooth project!
(Edited)The designer has replied
1
Reply
Thank you! :)
0
Reply
Print Profile
Regular print, 0.2mm layer, 2 walls, 15% infill
printed just fine, I would’ve liked to see an extra wall but for it’s purpose should be good!
0
Reply
Print Profile
0.16mm layer, 3 walls, 8% infill
Works perfectly!
0
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 9% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld