HueForge design inspired by the 404 error message shown on Tesla website.
Print at 100% infill with a layer height of 0.12mm with a base layer of 0.2mm
Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
Start with Charcoal
At layer #4 (0.56mm) swap to Red
At layer #8 (1.04mm) swap to Silver
At layer #12 (1.52mm) swap to Jade White for the rest.
If you enjoy my models, please consider supporting me and my future designs!