Enjoy my detailed, yet abstract model of an angel which can perfectly be used as christmas decoration.
It consists of four parts, which can be assembled without additional tools, it just uses a press fit. Simply push the pins of the wings into the holes on the main body. Be careful when handling the wings, I recommend holding them at the edge near the pin.
Warning: If you use default settings to print the wings the print will more than likely fail. I highly recommend using the print profile I uploaded because these are the best settings I could find after a lot of testing. With these settings the prints should be pretty easy.
If you want the middle of the heart on the main body to have a different color, simply use the color painting tool in BambuStudio to select your favourite color.
It's fine to use the standard 0,2 mm layer hight for all parts, but I used 0,12 mm layer hight to give them a bit more detail. The textured PEI plate worked really well for all parts.
For my print I used Bambu PLA Matte White and Bambu PLA Basic Red which worked perfectly.
Note: The wings are based on the design of sokutaban on thingiverse, but I changed the ball joint he used to a pin system and also made the lower part a bit thicker because it tends to break easily. (thingiverse.com/thing:3280207 - licensed under the Creative Commons - Attribution license (creativecommons.org/licenses/by/4.0/), free to share and adapt for any purpose.)
All other parts are created by me only.