A rack for a Micro-ATX board.

Perfect fit for my Asus B550m motherboard.

Since I had a little trouble to find the exact measurements for the holes, a table with these and a DXF with the holes are included. Measurements both in Inch and mm.

The measurements are based on the official measurements.

Altough the rack is smaller as the bed of the Bambu Lab X1 and P1 it crosses the exclusion area at the left bottom. A special STL and print profile is added. Here the left bottom corner is separated from the rack. After printing, click and glue it together. If you have a bigger printer use the normal STL or STP.

Happy modding :)