Spool Weight for AMS by sgauvin

sgauvin

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.9 h

1 plate

4.8(43)

Boost

160

415

313

Released

Description

This is a Spool Weight for AMS for spool with a center hole of 53.5mm and more.

It's designed for Bambu Spool Reusable and work with many others like eSun (plastic), Duramic 3D cardboard, Eryone cardboard…

I fill the spool weight with aquarium gravel, but you can use other material.

Comment & Rating (50)

@HessenBub

Thanks for this great AMS weight spool

The designer has replied

@sgauvin

Thank you. Your print look very good.

@wdarosh

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect for what I needed. I had some backstock of stainless steel chain rings that have no project that I could fill them with. For some of my spools they would be too small so I whipped up a quick adaptor plate so I could make them work for anything.

@ACEHOLE3D

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed great. Fits inside Bambi spool perfectly to hold one of these (https://a.co/d/0YhEjTF) for when the filament is running low! Thanks again!

@tundra3866cda

Print Profile

0.2mm layer, 2 walls, 15% infill

Great design. I am going to remix the screw on top by cutting out underneath the lid to provide room for a D size battery to fit within the hollowed out area. Finally find a use for a pair of weak flashlight batteries. Edit to show the re-mixed lid. Middle pic shows original lid on the bottom and the new altered lid on top. Third pic shows a D cell battery just fitting. Adds quite a bit of weight.

(Edited)

@JumboSwart

Print Profile

0.2mm layer, 2 walls, 15% infill

used bearings inside and works great

@timbo0674

Print Profile

0.2mm layer, 2 walls, 15% infill

Passt perfekt.

@TinyTheClown

Print Profile

0.2mm layer, 2 walls, 15% infill

worked so go the first time, I printed 2 more for stand by. it does stick out on the smaller rolls, however it fits great in the AMS.

@3DNYdesign

Print Profile

0.2mm layer, 2 walls, 15% infill

works

@strakiller120

Print Profile

0.2mm layer, 2 walls, 15% infill

leider sind die Gewinde mangelhaft man kann die Rollen garnicht richtig zusammen schrauben

The designer has replied

@sgauvin

Sorry to know that, but I have many of that and I don't have problem with thread.

@cgpro_

Probier mal etwas Fett auf die Gewinde zu geben. Evtl. gehts dann besser. (Try applying some grease to the threads. It may then work a bit better) Also wirklich gaaanz wenig... ;-)

(Edited)