Summary

Adapter to hold MiniDSP Umik-1 calibration microphone on a standard camera tripod mount. Recommend threading the bolt into this adapter a couple of times before clipping in the mic. It's fairly snug but after initial threading it holds very well. Microphone is held in place by pressure fit which is also very snug. Depending on your printer, check that all edges are smooth and sand if needed to prevent any scratching.

Comment & Rating (3)

@larryfunkster

This was exactly what I needed. Thank you! Printed it with the recommended settings and it turned out great. No adjustments were required for fitment. I appreciate the designers notes to pay attention to edges so as not to scratch the mic. I'm not sure how the rating system works or how to publish the settings I used but this is a 5 star rating all around.

(Edited)

@larryfunkster

Print Profile

0.2mm layer, 2 walls, 15% infill

exactly what I needed. printed perfectly. appreciate the designers attention to detail pointing out to sand any sharp edges so as not to scratch the mic.