Air Jordan Jumpman Lightbox with 3D Faceplate by dakjones82

dakjones82

Art>Signs & Logos

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill quality settings

Designer

12.3 h

5 plates

4.3(8)

Diffuser Only Profile 0.16mm layer, 2 walls, 15% infill

Designer

29 min

1 plate

Boost

105

Released

Description

This approach is a bit different than the standard flat-face lightboxes. It requires a few more prints and a bit more work on the assembly side but the results provide more depth than the more popular methods of making these. I've been building boxes like this before it became a trend. Parts are printed face down so you can take advantage of nicer surface options like the textured build plates.

Give the faceplate/lid a quicksand for good glue adhesion and then line up the diffuser with the back of the faceplate and glue in place. Use your choice of super glue for the diffuser.

LED used are fully addressable WS2812B and can be found here: https://www.amazon.com/dp/B08H26BD5Z?psc=1&ref=ppx_yo2ov_dt_b_product_details

The cables are all hand-sleeved and shrink-wrapped using the following items:

Shrink Tube: https://www.amazon.com/dp/B07FPDBGYH?psc=1&ref=ppx_yo2ov_dt_b_product_details

Cable Loom/Sleeve: https://www.amazon.com/dp/B07FW86XV6?psc=1&ref=ppx_yo2ov_dt_b_product_details

Comment & Rating (10)

@user_4140530830

Print Profile

0.2mm layer, 3 walls, 15% infill quality settings

The fit of the diffuser was a bit difficult to get laid in right. Maybe more like a Lightbox would have been a better design.

The designer has replied

@dakjones82

thank you for the rating the print. These are a little harder than a standard light box but the trade off is the 3d design aesthetic. There should be other "Flat face" light box models out there if you prefer the easier method.