Car cigarette lighter plug
Copyright Claim
Car cigarette lighter plug
Boost
13
26
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, top layer ironing
Designer
22 min
1 plate
Boost
13
26
5
0
66
66
Released
Description
I made this when I lost the original cigarette lighter plug in my car.
Tested on an BMW, but it should work for all 12v sockets in cars.
Print standing as picture shows with outer supports. I printed mine in PLA, but if you live in a warmer climate, ABS, ASA or PETG is prefered.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, top layer ironing
Nice design, but was abit small, so ended up wrapping one piece of electrical tape to have a snug fit.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, top layer ironing
worked out well
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, top layer ironing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, top layer ironing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, top layer ironing
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld