Lot of diffusers to reduce the points of light emitted by IP20/IP30 LED strips.
I use them on shelves and places where the LED strip is visible. I mainly use natural white PLA+ because it is the most balanced to allow light to pass through and diffuse it. The transparent is more for protection and elegance than for blurring.
I have added a V2 version with small curvatures in the thin clips so that diffusers can be added. These will remain anchored without the need for additional external clips.
So far I have not had a problem with heat since I use low density LED strips, but if you decide to use these diffusers with high density LED strips, take into account the melting temperature of the material you will print with so that there is no warping over time.
Believe me: I have seen LED strips that reach 60 degrees in temperature and with 2 LED strips inserted in PLA and at maximum
performance it is very likely that this will end very badly.
If you already have other LED strips installed directly and want to add diffusers, I recommend that you see the design of my type of diffusers with IP68 clips: