Ecobee SmartSensor Battery Cap
Copyright Claim
Ecobee SmartSensor Battery Cap
Boost
2
1
2
Print Profile(0)
Add the first print profile to earn points
Boost
2
1
2
0
2
0
Released
Description
My Ecobee SmartSensor took a dive off a shelf and the battery cap went flying – straight to the air conditioning vent and down into the depths.
I contacted Ecobee to see if I could get a replacement flimsy piece of plastic, and all they offered was that I could buy a new SmartSensor for US$50. Calipers, Fusion 360, and my Bambu X1C to the rescue!
Printed well with both a 0.4mm nozzle at 0.12mm layer height as well as a 0.2mm nozzle at 0.08mm layer height. The 0.2mm nozzle settings seated better. I used the default settings in Bambu Studio and printed it in Bambu PLA.
Comment & Rating (2)
All
Thank you for this, same happened to me, lost the cover. I Found this, printed it in pla with 0.4 nozzle and selected extra fine .08 layer height, printed flawlessly and snapped right in. saved me $50, I thank you good sir. printed on a P1S
(Edited)The designer has replied
1
Reply
Glad I'm not the only one. We've nearly dismantled and reorganized our kitchen (where we lost the back) and it's still nowhere to be found. Printed cap working great. :D
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld